Configuration of an Upstream Port-HUAWEI

*******GPON Upstream Port Configuration********

Assume that the 0/19/0 and 0/19/1 upstream ports are to be added to VLAN 50. The 0/19/0 and 0/19/1 need to be configured into an aggregation group for double upstream accesses. For the two upstream ports, the working mode is full-duplex (full) and the port rate is 100 Mbit/s. To configure such upstream ports, do as follows:

OLT(config)#port vlan 50 0/19 0   
OLT(config)#port vlan 50 0/19 1  
OLT(config)#interface giu 0/19 
OLT(config-if-giu-0/19)#duplex 0 full
OLT(config-if-giu-0/19)#duplex 1 full
OLT(config-if-giu-0/19)#speed 0 100
OLT(config-if-giu-0/19)#speed 1 100
OLT(config-if-giu-0/19)#quit 
OLT(config)#link-aggregation 0/19 0 0/19 1 egress-ingress workmode lacp-static

                                     *****END*****

Be the first to comment

Leave a Reply

Your email address will not be published.


*


For security, use of Google's reCAPTCHA service is required which is subject to the Google Privacy Policy and Terms of Use.

I agree to these terms.