Configuration of Anti-Theft and Roaming of User Account Through PITP-HUAWEI

*****Anti-Theft and Roaming of User Account Through PITP*****

Follow the following configuration:

  • RAIO mode: user-defined mode
  • CID format for the Ethernet access mode: shelf ID/slot ID/port ID:VLAN ID
  • CID format for the xPON access mode: shelf ID/slot ID/port ID:ONT ID.VLAN ID

To enable the PITP P mode of service port 1 under port 0/1/0, do as follows:

OLT(config)#raio-mode user-defined pitp-pmode
OLT(config)#raio-format pitp-pmode cid eth anid eth frame/slot/port:vlanid 
OLT(config)#raio-format pitp-pmode cid xpon anid xpon frame/slot/port:ontid.vlanid
OLT(config)#raio-format pitp-pmode rid eth plabel
OLT(config)#raio-format pitp-pmode rid xpon plabel
OLT(config)#pitp enable pmode
OLT(config)#pitp port 0/1/0 enable 
OLT(config)#pitp service-port 1 enable

Follow the following configuration:

  • RAIO mode: user-defined mode
  • CID/RID format for the Ethernet access mode: shelf ID/slot ID/port ID:VLAN ID
  • CID/RID format for the xPON access mode: shelf ID/slot ID/port ID:ONT ID.VLAN ID

To set the Ethernet protocol type of VBRAS packets to be the same as that of the upper-layer BRAS, that is, 0x8500, and enable the PITP V mode of service port 0, do as follows:

OLT(config)#raio-mode user-defined pitp-vmode
OLT(config)#raio-format pitp-vmode eth anid eth frame/slot/port:vlanid
OLT(config)#raio-format pitp-vmode xpon anid xpon frame/slot/port:ontid.vlanid
OLT(config)#pitp vmode ether-type 0x8500  
OLT(config)#pitp enable vmode
OLT(config)#pitp port 0/2/0 enable   
OLT(config)#pitp service-port 0 enable 

                                         *******END******

Be the first to comment

Leave a Reply

Your email address will not be published.


*


For security, use of Google's reCAPTCHA service is required which is subject to the Google Privacy Policy and Terms of Use.

I agree to these terms.