Configuration of the NTP Peer Mode-HUAWEI

*********NTP Peer Mode-GPON********

Let the following configurations: One MA5600T functions as the NTP active peer (IP address of the L3 interface of VLAN 24: 10.10.5.10/24) and works on clock stratum 4, the other MA5600T (IP address: 10.10.10.20/24) functions as the NTP passive peer, the active peer sends a clock synchronization request packet through the VLAN L3 interface to the passive peer, the passive peer responds to the request packet, and the peer with a higher clock stratum is synchronized by the peer with a lower clock stratum. To perform these configurations, do as follows:

OLT(config)#ntp-service refclock-master 4
OLT(config)#ntp-service unicast-peer
OLT(config)#vlan 24 standard
OLT(config)#port vlan 2 0/19 0
OLT(config)#interface vlanif 24
OLT(config-if-vlanif2)#ip address 10.10.5.10 24
OLT(config-if-vlanif2)#quit

                                     ******END******

Be the first to comment

Leave a Reply

Your email address will not be published.


*


For security, use of Google's reCAPTCHA service is required which is subject to the Google Privacy Policy and Terms of Use.

I agree to these terms.