Configuration of the Uplink Redundancy Backup-HUAWEI

*********Uplink Redundancy Backup********

Assume the following configurations: The MA5600T transmits services upstream through the GIU slot, upstream ports 0/19/0 and 0/19/1 on the same GIU slot are configured as an upstream port aggregation group, packets are distributed to the member ports of the aggregation group according to the source MAC address, and the working mode is the LACP static aggregation mode. To perform these configurations, do as follows:

OLT(config)#link-aggregation 0/19 0-1 egress-ingress workmode lacp-static

Assume the following configurations: The MA5600T transmits services upstream through the GIU slot, upstream ports 0/19/0 and 0/19/1 on the same GIU slot are configured as an inter-board aggregation group, packets are distributed to the member ports of the aggregation group according to the source MAC address, and the working mode is the LACP static aggregation mode. To perform these configurations, do as follows:

OLT(config)#link-aggregation 0/19 0 0/20 0 egress-ingress workmode lacp-static

Assume the following configurations: The MA5600T transmits services upstream through the GIU slot, upstream ports 0/19/0 and 0/19/1 on the same GIU slot are configured as an upstream port protection group, port 0/19/0 functions as the active port, port 0/19/1 functions as the protection port, the working mode is the delay detection mode, and enable the protection group function. To perform these configurations, do as follows:

OLT(config-protect)#protect-group first 0/19/0 second 0/19/1 eth workmode timedelay enable

Assume the following configurations: The MA5600T transmits services upstream through the GIU slot, the ports on the active and standby GIU slots are configured as a inter-board protection group, the port in slot 0/19 functions as the active port, the port in 0/20 functions as the protection port, the working mode is the delay detection mode, and the protection group function is enabled. To perform these configurations, do as follows:

OLT(config-protect)#protect-group first 0/19 second 0/20 eth workmode timedelay enable

                                          *****END*****

Be the first to comment

Leave a Reply

Your email address will not be published.


*


For security, use of Google's reCAPTCHA service is required which is subject to the Google Privacy Policy and Terms of Use.

I agree to these terms.